|
The DT3034 is a high performance, high resolution DAQ board for the PCI bus that offers 16-bit measurements on up to 32 single-ended or 16 differential channels with a sampling rate of 500kHz. With an ENOB (Effective Number of Bits) rating of over 14.2 bits, this is the most accurate PCI board available. And the SNR (Signal-to-Noise Ratio) of 100dB provides the ultimate in clean signal measurements. The DT3034 can operate multiple subsystems simultaneously at full speed without the loss of any data.
Key Features:
- 500kHz throughput on 32 SE/16 DI, 16-bit analog input channels.
- Two, 500kHz, 16-bit deglitched waveform analog output channels to generate signals to stimulate systems under test
- 16 clocked digital I/O driving solid state relays
- Flexible triggering and clocking modes accommodate all application needs
- Four 16-bit counter/timers for event counting or frequency measurement
- 1024-location channel-gain list for flexible scanning at a variety of gains
|
The DT3034 is a high-performance, high-resolution data acquisition board.
This graph shows the outstanding quality of the DT3034 when switching channels at full scale for all error sources...with an ENOB (Effective Number of Bits) rating of 14.2 bits and an SFDR (Spurious Free Dynamic Range) of 100dB. Since this is worst case, most users in normal conditions would get even better ENOB rating
Note: Signal-to-Noise ratio plus Distortion (the sum of all peaks) is 87dB.
|
