Data Translation Home:
US/Canada
|
Europe/Asia
Data Translation Knowledge Base
Home
/
All Categories
/
Data Acquisition Hardware
/
USB
Knowledge Base Home
|
Search
|
Glossary
List of articles available in "USB"
RSS Feed
"Power Surge On Hub Port" error message
What is the specified USB port supply voltage range?
USB Device Serial Number
What is the maximum USB cable length recommended for DT USB products?
USB latencies and buffer sizes
'What are the Common Mode Voltage and Common Mode Rejection Ratio for DT PCI boards and USB modules?
The computer is not recognizing my Data Translation USB data acquisition (DAQ) module. "Unknown Device" error msg displayed. Device may have been accidentally connected to the USB port, befo
Error using USB devices with ACER computer
When I connect my Data Translation USB data acquisition (DAQ) device to my computer, the computer asks to install new drivers.
What do the specifications IOL and IOH stand for?
Linux Support for Data Acquisition Boards
My Econ USB device is not being recognized by my pc.
What is internal impedance and why is it important?
What is monotonic and what does it have to do with data collection?
My ECON USB module is not functioning properly, but was working perfectly yesterday.
Do the PCI and USB data acquisition drivers work with hyper-threading, dual processor or multi-core processing systems?"
What is the length of the USB cable that ships with the Econ module and what is the maximum recommended cable length
After sampling my A/D input channels in continuous mode, the system responds with the error "WM_OVERRUN_ERROR".
How can I resolve an underrun error?
Does the USB module get connected to the USB port first or should the drivers be installed first?
What is the difference between 500V isolation and 8000V ESD protection with the DT USB modules
My Econ module was not detected on restart or from hibernation
My Econ USB device was working great, and then it just stopped working. My application even locks up (does not respond)."
Will the Econ device be damaged if the analog output is shorted to ground?
What is the best type of computer to use with the ECON series?
When attempting to output a square pulse wave from the Counter/Timer (Rate Generation), I notice that the rise time of the square wave takes a long time (~112 nsec) and therefore looks like a sawtooth
What type of signal does the digital I/O section of the DT9817 generate?
I accidently entered a large value for the olDaSetClockFreq, but the program did not return with an error message. Is it supposed to?"
I have a DT device and am viewing several channels on my display, but I only have one channel connected to a signal source. Shouldn't the channels that are not connected display 0 volts."
How do I use the emulator and DSPLAB with host communications?
When computing a histogram over time of random noise some amplitude values appear more frequent than others.
How much current does the 5 volt PIN #20 supply on the ECON Modules?
Which boards are considered part of the ECON Series?
The computer is not recognizing my DT USB module (""Unknown Device"" error msg.).
What is the power consumption of an Econ series device?
What is the maximum input voltage for the Counter/Timer?
What is the isolation between the inputs when they work in single-ended vs differential mode, and what is the DC isolation between the inputs and the inputs to ground?
Does the digital input create window's events?
Is my PC protected from an electrical shock with an Econ device?
Why do I get an ""isochronous transfers end points" error message when using my usb device with a wireless usb hub?
I have a choice between NPN and PNP type sensors. Which one should I use with your board and how do I connect it?
Setting Different Gains, DT9805
Subcategories available under "USB"
There are no subcategories available.